Flat-Pack Overlay Alignment Jig for KDM20 & KDM20G Keypads (MultiCam USA)
Alignment jig for replacing the overlay and button layer on KDM20 and KDM20G handheld keypads from MultiCam USA CNC cutting machines. It holds the keypad circuit board in one fixed position, so the button layer and overlay go down in exactly the right place the first time.
Why alignment matters: the adhesive on the button layer and overlay is thick, very sticky and permanent. It does not release and cannot be repositioned. If a layer goes down even slightly off, it can't be peeled back and re-laid without destroying it, and the buttons no longer sit over their dimples. A misaligned overlay or button layer is scrap. That's up to US$290 in replacement parts (overlay US$155, button layer US$135), plus shipping again and more days with the machine out of action. The jig pays for itself the first time it saves a layer.
The jig's locating plug fits the E-stop cavity in the keypad board, so the board can only sit one way round and in one position. It then rests on nine support ledges inside a guide frame shaped to the keypad outline. With the board locked in place, you check the dimple alignment and lower each layer straight down, with no sliding and no guesswork.
Supplied flat-packed with printed assembly instructions. In the kit: 1 base sheet, 1 upper guide frame, 9 support clips, 2 slotted E-stop wafers and 1 round wafer socket. The clips and frame click together without glue; only the wafer socket is fixed to the base with a drop of superglue (not supplied). Assembly takes a few minutes, and the finished jig sits flat on the bench and can be reused for every keypad you repair.
Bundle offer: buy the jig and every KDM20G replacement overlay and button layer in the same order is 25% off (up to 10 parts, no code needed); take the complete set and the jig is 25% off too. Pick a bundle below: one click puts everything in your order with the discount already applied.
Jig + overlay (CNC Router) → save US$38.75
Jig + overlay (CNC Plasma / Laser) → save US$38.75
Jig + button layer → save US$33.75
Complete set: jig + Router overlay + button layer → 25% off all three, save US$110
Complete set: jig + Plasma / Laser overlay + button layer → 25% off all three, save US$110
Choose the overlay that matches your machine (CNC Router, or CNC Plasma / Laser). Not sure? Just ask us before you order.
Designed and made in Australia by kdm20g.com.
Note: Use with our KDM20G replacement overlay and button layer. For the full strip-down and rebuild, see our KDM20G Overlay Replacement Guide in the Tech Hub.